Frigidaire FCGM181RQB Owner's Guide download pdf (Page 5)

5

First Steps

Front Fixed Caster Installation

Locate and align xed caster (with brake lever

facing front of unit - see Figure 3) over the

same mounting holes from bracket in Figure 1

using 6 hex screws (3 for each caster). Secure

the screws snug using a ⅜” open end wrench.

Repeat this procedure for opposite corner. DO

NOT OVERTIGHTEN.

Rear Swivel Caster Installation

1. Remove and discard the screws shown in

Figure 4 from each bottom corner using a

5/16” socket wrench.

Brake lever

Fixed

caster

Front

of unit

Hex

Screws

(3)

Figure 3

Remove screw

before installing

caster. Repeat

for opposite

corner

Figure 4

2. Locate and align swivel caster over the

holes and install with 2 hex screws.

Secure the screws snug using a 3/8”

socket wrench. DO NOT OVERTIGHTEN.

3. On the opposite side of the swivel caster

plate, insert 2 carriage bolts through the

compressor support rail and swivel caster

plate. Use a lock nut on each bolt and

tighten securely using a 9/16” socket

wrench. See Figure 5.

Install caster

using (2) hex

screws

(2) Carriage

bolts with

lock nut

Swivel caster

Figure 5

4. Repeat the same procedure for the

opposite rear corner.

5. With the help of an assistant, carefully

upright the unit. Reassemble the rear

access guard with screws.

CAUTION

Unit will roll forward as it is tipped up.

Appliance Placement

Leave a 1” space on all sides and the back of

the cabinet for ease of installation, proper air

circulation and electrical connections. DO NOT

block the front grill on the lower front of your

appliance. Sufcient air circulation is essential

for the proper operation of your appliance.

Choose a place that is near a grounded electrical

outlet. For the most efcient operation, the

appliance should be located where surrounding

temperatures will not drop below 40ºF (5ºC)

or exceed 110ºF (43ºC). Additional compressor

heaters are not recommended.

Insulation

The insulated space of this cabinet is sealed

to maintain peak efciency. Holes drilled in

the cabinet may destroy that seal and damage

electrical wiring located in the insulated space.

DAMAGED ELECTRICAL WIRING OR

WET INSULATION CAUSED BY DRILLING

WILL VOID THE WARRANTY.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments