Frigidaire FFET1222QW Use and Care Guide Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
4
NOTE
The exterior walls of the refrigerator may become quite
warm as the compressor works to transfer heat from
the inside. Temperatures as much as 30° F warmer than
room temperature can be expected. For this reason it is
particularly important in hotter climates to allow enough
space for air circulation around your refrigerator.
Leveling
The refrigerator must have all bottom corners resting
rmly on solid oor. The oor must be strong enough
to support a fully loaded refrigerator. NOTE: It is very
important for your refrigerator to be level in order to
function properly. If the refrigerator is not leveled during
installation, the door may be misaligned and not close or
seal properly, causing cooling, frost, or moisture problems.
To Level Your Refrigerator:
After removing all interior and exterior packing materials,
crating screws and wood base, use a carpenter’s level
to level the refrigerator from front-to-back. Adjust the
plastic leveling feet in front, ½ bubble higher, so that the
door closes easily when left halfway open.
NOTE
The direction in which your refrigerator doors open
(door swing) can be reversed, from left to right or right
to left, by moving the door hinges from one side to the
other. Reversing the door swing should be performed
by a qualied person.
INSTALLATION
This Use & Care Guide provides general operating
instructions for your model. Use the refrigerator only as
instructed in this Use & Care Guide. Before starting the
refrigerator, follow these important rst steps.
Location
Choose a place that is near a grounded electrical outlet.
Do Not use an extension cord or an adapter plug.
For the most efcient operation, the refrigerator
should be located where surrounding temperatures
will not drop below 10° F (-12° C) or exceed 110° F
(43° C). The Freeze Control Feature is designed
to automatically maintain the selected interior
refrigerator temperature within these boundaries.
Allow space around the unit for good air circulation.
Leave a 2 inch (50 mm) space on the back, 1 inch
(20 mm) on the sides, and 12 inches (300 mm)
above the refrigerator for adequate circulation.
Door Parts
Top Hinge
Top Hinge Shim
Center Hinge
Center Hinge Shim
Bottom Right Hinge
Right Pin Assembly (2)
Parts included with Hinge Kit (packed inside unit)
Bottom Left Hinge
Left Pin Assembly (2)
Hole Plug (3)
IMPORTANT
Before you begin, unplug the electrical power cord from
the wall outlet. Remove any food from door shelves.
DOOR REVERSAL INSTRUCTIONS
You should nd a hinge kit packed inside your unit with the
following parts that will be needed to reverse the doors:
Page view 3
1 2 3 4 5 6 7 8 9 ... 35 36

Comments to this Manuals

No comments