Frigidaire FGHB2866PP User Manual Page 37

  • Download
  • Add to my manuals
  • Print
  • Page
    / 41
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 36
37
BEFORE YOU CALL
Visit our web site at
www.frigidaire.com
1-800-944-9044 (United States)
1-800-265-8352 (Canada)
CONCERN POTENTIAL CAUSE COMMON SOLUTION
AUTOMATIC ICE MAKER
Ice maker is
not making
any ice.
• Ice maker is turned off.
• Refrigerator is not connected
to water line or water valve
is not open.
• The water supply line is
kinked.
• Thewaterlterisnotseated
properly.
• Thewaterltermaybe
clogged with foreign
material.
• Freezer ice maker wire signal
arm is being held up by an
item not allowing it to go in
the on or down position.
• Turn on ice maker. For the fresh food ice maker,
press and hold the “Ice Off” button for three
seconds until the indicator light is off. For the
freezer ice maker, lower the wire signal arm.
• Connect the unit to the household water supply
and ensure the water valve is open.
• Ensure that the supply line does not kink when
the refrigerator is pushed into place against the
wall.
• Removeandre-installthewaterlter.Besure
topushthelterrmlysothatyouhearitlock
solidly into position.
• If water dispenses slowly or not at all, or if the
lterissixmonthsoldorolder,itshouldbe
replaced.
• Move any item or frozen ice cubes that may
block the signal arm from being in the on or
down position. See Automatic Ice Maker-Freezer
section in manual.
Ice maker is
not making
enough ice.
• Ice maker is producing less
ice than you expect.
• Thewaterltermaybe
clogged with foreign
material.
• The water supply line is
kinked.
• Saddle valve on cold water
pipe is clogged or restricted
by foreign material.
• Heavytrafc,opening
or closing of the doors
excessively.
• Freezer control is set too
warm (freezer ice maker).
• Water pressure is extremely
low. Cut-off and cut-on
pressures are too low (well
systems only).
• Reverse osmosis system is in
regenerative phase.
• The fresh food and freezer ice makers will each
produce approximately 2.5 pounds of ice every
24 hours depending on usage conditions.
• If water dispenses slower than normal, or if
thelterissixmonthsoldorolder,itshouldbe
replaced.
• Ensure that the supply line does not kink when
the refrigerator is pushed into place against the
wall.
• Turn off household water line valve. Remove
valve. Ensure that valve is not a self-piercing
saddle valve. Clean valve. Replace valve if
necessary.
• Press Fast Freeze to temporarily increase ice
production rate. (Freezer ice maker only.)
• Set freezer control to colder setting to improve
performance of the ice maker (freezer ice maker).
Allow 24 hours for temperature to stabilize.
• Have someone turn up the cut-off and cut-
on pressure on the water pump system (well
systems only).
• It is normal for a reverse osmosis system to be
below 20 psi during the regenerative phase.
Page view 36
1 2 ... 32 33 34 35 36 37 38 39 40 41

Comments to this Manuals

No comments