Frigidaire FPEF4085KF User Manual download pdf (Page 3)

40" ELECTRIC RANGE INSTALLATION INSTRUCTIONS

NOTE: Range is shipped from factory with 1 1/8" dia. hole

as shown in ﬁ gure 3. If a larger hole is required, punch out

the knockout.

Model and Serial Number Location

The serial plate is located on the oven front frame behind

the large oven door.

When ordering parts for or making inquiries about your

range, always be sure to include the model and serial

numbers and a lot number or letter from the serial plate

on your range (Figure 1).

Serial Plate Location

1. Power Supply Cord Kit

The user is responsible for connecting the power supply

cord to the connection block located behind the back

panel access cover.

This appliance may be connected by means of

permanent "hard wiring"; ﬂ exible armored or

nonmetallic shielded copper cable (when local code

allow it) or by means of a power supply cord kit.

Risk of ﬁ re or electrical shock exists

if an incorrect size range cord kit is used, the

Installation Instructions are not followed, or the

strain relief bracket is discarded.

For mobile homes, new installations or recreational

vehicles, use only a power supply kit designed for a

range at 125V/250V 50A recommended (minimum

40A). Cord must have either 3 (when local code permits

grounding through neutral) or 4 conductors. Terminal on

end of wires must be either closed loop or open spade

lug with upturned ends. Cord must have strain-relief

clamp.

Do not loosen the nuts which secure

the factory-installed range wiring to terminal block

while connecting range. Electrical failure or loss of

electrical connection may occur.

2. Access to Terminal Block &

Grounding Strap

Electrical Shock Hazard

• Electrical ground is required on this appliance.

• Do not connect to the electrical supply until

appliance is permanently grounded.

• Disconnect power to the circuit breaker or fuse

box before making the electrical connection.

• This appliance must be connected to a grounded,

metallic, permanent wiring system, or a

grounding connector should be connected to the

grounding terminal or wire lead on the appliance.

Failure to do any of the above could result in a

ﬁ re, personal injury or electrical shock.

Figure 2

Figure 1

To gain access to lower terminal

block bend lower back cover plate

along row of holes shown here

This appliance is manufactured with

the frame grounded by connection of a grounding

strap between the neutral power supply terminal

and the frame. If used in USA, in a new branch

circuit installation (1996 NEC), mobile home or

recreational vehicle, where local code do not

permit grounding through neutral (white) wire

or in Canada; remove the grounding strap from

the frame and cut the other end, near the neutral

terminal. Connect the appliance in usual manner.

1 2 3 4 5 6 7 8 ... 19 20

Comments to this Manuals

No comments

Frigidaire FPEF4085KF User Manual Page 3

Comments to this Manuals

Related products and manuals for Kitchen Frigidaire FPEF4085KF