Frigidaire CFEF2422RS Information Sheet download pdf (Page 2)

24" (600 mm) ELECTRIC RANGE INSTALLATION INSTRUCTIONS

(For 4 Wire, 60 Hz. Systems)

IMPORTANT SAFETY

INSTRUCTIONS

If the information in this manual is not followed

exactly, a ﬁre or electrical shock may result causing property

damage, personal injury or death.

Tip Over Hazard

Range

leveling leg

Anti-tip

bracket

• A child or adult can tip the

range and be killed.

• Verify the anti-tip device has

been installed to floor or wall.

• Ensure the anti-tip device is re-engaged to floor

or wall when the range is moved.

• Do not operate the range without the anti-tip

device in place and engaged.

• Failure to follow these instructions can result in

death or serious burns to children and adults.

To check if the anti-tip bracket is installed properly, use

both arms to grasp the rear edge of the range back.

Carefully attempt to tilt range forward. When properly

installed, the range should not tilt forward.

Refer to the anti-tip bracket installation instructions

supplied with your range for proper installation.

Important Notes to the Installer

1. Read all instructions contained in these installation

instructions before installing range.

2. Remove all packing material from the oven compartments

before connecting the gas and electrical supply to the

range.

3. Observe all governing codes and ordinances.

4. Be sure to leave these instructions with the consumer.

Important Note to the Consumer

Keep these instructions with your owner's guide for future

reference.

• As when using any appliance generating heat, there are

certain safety precautions you should follow. These are

listed in the Use & Care Manual, read it carefully.

• Be sure your range is installed and grounded properly

by a qualied installer or service technician.

• Make sure the wall coverings around the range can

withstand the heat generated by the range.

• To eliminate the need to reach over the surface elements,

cabinet storage space above the elements should be

avoided.

Before Starting

Tools You May Need

For leveling legs and Anti-Tip Bracket:

• Adjustable wrench or channel lock pliers

• 5/16" (21 mm) Nutdriver or Flat Head Screwdriver

• Electric Drill & 1/8" (3 mm) Diameter Drill Bit (Masonry

Drill Bit if installing in concrete)

Additional Materials You May Need

• Copper Electrical Wiring & Metal Conduit (for hard wiring)

Normal Installation Steps

1. Anti-Tip Bracket Installation Instructions

Important Safety Warning

To reduce the risk of tipping of the range, the range should

be secured to the oor by properly installed anti-tip bracket

and screws packed with the range. Failure to install the

anti-tip bracket will allow the range to tip over if excessive

weight is placed on an open door or if a child climbs upon

it. Serious injury might result from spilled hot liquids or from

the range itself.

If range is ever moved to a different location, the anti-tip

brackets must also be moved and installed with the range.

Instructions are provided for installation in wood or cement

fastened to either the oor or wall. When installed to the

wall, make sure that screws completely penetrate dry wall

and are secured in wood or metal. When fastening to the

oor or wall, be sure that screws do not penetrate electrical

wiring or plumbing.

A. Locate the Bracket Using the Template - (Bracket may

be located on either the left or right side of the range. Use

the information below to locate the bracket if template is

not available). Mark the oor or wall where left or right

side of the range will be located. If rear of range is against

the wall or no further than 1-1/4" (32 mm) from wall when

installed, you may use the wall or oor mount method. If

molding is installed and does not allow the bracket to t

ush against the wall, remove molding or mount bracket

to the oor. For wall mount, locate the bracket by placing

the back edge of the template against the rear wall and

the side edge of template on the mark made referencing

the side of the range. Place bracket on top of template

and mark location of the screw holes in wall. If rear of

range is further than 1-1/4" (32 mm) from the wall when

installed, attach bracket to the oor. For oor mount,

locate the bracket by placing back edge of the template

where the rear of the range will be located. Mark the

location of the screw holes, shown in template.

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Frigidaire CFEF2422RS Information Sheet Page 2

Comments to this Manuals

Related products and manuals for Unknown Frigidaire CFEF2422RS