Frigidaire FFLG2022MW User Manual download pdf (Page 3)

Top Load Laundry Center

FFLG2022MW Gas

Specifications

subject to change.

USA

•

10200 David Taylor Drive

•

Charlotte, NC 28262

•

1-800-FRIGIDAIRE

•

frigidaire.com

CANADA

•

5855 Terry Fox Way

•

Mississauga, ON L5V 3E4

•

1-800-265-8352

•

frigidaire.ca

Top Load Laundry Center Specifications

• Product Shipping Weight (approx.) – 275 Lbs.

• Designed for HOME USE only, not recommended for commercial

application.

• An electrical supply with grounded three-prong receptacle is

required. The power supply circuit must be installed in accordance

with current edition of National Electrical Code (ANSI/NFPA 70)

and local codes & ordinances.

• Voltage Rating – 120V / 60 Hz / 15 Amps

• Amps @ 120 Volts = 13 Amps

• Connected Load (kW Rating) @ 120 Volts = 1.03 kW

• Unit equipped with 120V 3-wire power supply cord, approx, 60" long.

• Always consult local and national electric, plumbing & gas codes.

• Can be installed in recess or closet requiring 0" minimum installation

clearance around sides and back of unit. To achieve 0" minimum rear

clearance, dryer MUST be vented straight back. Closet installation

requires additional 1" minimum clearance between front of unit

and vented door. Door MUST be vented with 120 sq. in. minimum

louvered opening, equally divided, located 3" from top and bottom

of door. A louvered door with equivalent air openings for full-length

of door is acceptable. Air openings MUST remain unobstructed with

door installed. (For additional installation details, refer to Product

Installation Guide on web.)

• Do NOT install in area exposed to dripping water or outdoor weather

conditions; where gasoline or other flammables are kept or stored; or

where dryer comes in contact with curtains, drapes or anything that

will obstruct flow of combustion and ventilation air.

• For garage installation, dryer MUST be located minimum 18" above floor.

• Floor MUST be solid with 1" maximum slope. Do NOT install on

carpeted surface.

• Dryer MUST exhaust to outside of building, NOT into any concealed

space.

• Exhaust installation requires minimum 4"-diameter rigid or semi-rigid

metal duct with approved, unobstructed vent hood having swing-out

damper(s). If installing rigid metal duct (preferred), do not exceed

MAXIMUM venting run length of 56 ft., allow deductions for elbows

and vents. If installing semi-rigid metal duct, do not exceed MAXIMUM

venting run length of 8 ft., always allow deductions for elbows and

vents (Refer to Product Installation Guide on web for additional

information). Do NOT use flexible plastic or metal foil duct and use

shortest run possible.

• Flush-to-wall installation allows for 4-way exhausting — straight back,

down, left and right. While vertical exhausting is acceptable, certain

circumstances could affect dryer’s performance; and unit will be

positioned 4-1/2" from wall. (Flush-to-wall exhausting may be done

by going below dryer, then sideways.)

• H/C water faucets MUST be installed within 42" of washer’s water

inlet and MUST be 3/4" with threading for laundry hose connection

to connect to 48" inlet hoses.

• Water pressure MUST be between 10 and 120 psi with NOT more

than 10 psi pressure difference between hot and cold.

• Drain standpipe requires diameter of 1-1/4" min. and height of

33" min. / 96" max. above floor, capable of eliminating 17 gallons

per minute. Attached 52" drain hose can reach 74"-high standpipe.

For higher standpipe, optional Drain Hose Extension Kit available.

• Gas supply line should be 1/2" pipe and MUST have individual

shutoff valve.

• Leveling legs supplied to level dryer properly and reduce excessive

noise and vibration.

• For manufactured or mobile home installation optional Mobile Home

Installation Kit (PN # 137067200) required. (For specific installation

details, refer to Product Installation Guide on web.)

Note: For planning purposes only. Refer to Product Installation Guide

on the web at frigidaire.com for detailed instructions.

Optional Accessories

• Mobile Home Installation Kit – (PN # 137067200).

• Drain Hose Extension Kit – (PN # 134592700).

• LP Gas Conversion Kit – (PN # PCK3100).

• Drying Rack – (PN # DRLC).

Top Load Laundry Center - Gas (GLGT1031F)

Frigidaire Gallery

1 2 3

Comments to this Manuals

No comments

Frigidaire FFLG2022MW User Manual Page 3

Comments to this Manuals

Related products and manuals for Washers Frigidaire FFLG2022MW