TABLE OF CONTENTSwww.frigidaire.com USA 1-800-944-9044 www.frigidaire.ca Canada 1-800-265-8352All about theInstallationandUse & Car
104. Install Duct Transition to Blower Install the duct transition on the blower, using the three wide head Phillips screws. It is recommended for al
DUCT TAPE OVER SEAM AND SCREWScrewAir FlowDuct Tape Over Seam and ScrewDUCT ON-THE-FLOORDUCT THROUGH-THE-FLOOR116. Install Ductwork- Use galvanized or
DUCT PIECESEQUIVALENT LENGTH XNUMBER USED =EQUIVALENT LENGTH6" (15.2cm) Round Straight **1 Ft. (0.3m) Ft. or m6" (15.2cm) Round Metal F
13Operating the Telescoping Downdraft System- Raise the downdraft by pressing the raise/lower push button. The telescoping vent will rise up to full h
14Cleaning the Telescoping Downdraft VentWARNINGIt is advised to disconnect power from the downdraft when cleaning to minimize risk of electrical shoc
15BEFORE YOU CALL (Solutions to Common Problems)OCCURRENCE POSSIBLE CAUSE/SOLUTIONTelescoping Vent does not fully raiseCheck for and remove obstructio
16MAJOR APPLIANCE WARRANTYThis warranty does not cover the following:1 Products with original serial numbers that have been removed, altered or canno
Do not, under any circumstances, cut, remove, or bypass the grounding prong.Power supply cord with 3-prong grounding plugGrounding type wall receptacl
3IMPORTANT SAFETY INSTRUCTIONSWARNINGTO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:•Use this unit only in t
Tools You Will Need• Phillips Screwdriver• 1/4” Nut Driver / Ratchet• Tape Measure• Carpenter Square• Vertical Level or Plum Line• Tools r
5PRODUCT DIMENSIONSModel A B C D E RiseFH30DD50MS 30” (76.2 cm) 26 7/8” (68.3 cm)17 13/16” (45.2 cm)34 5/16” (87.2 cm)2 3/16” (5.5 cm)10” (25.4 cm)FH3
6PLANNINGBasic InformationA qualied technician must complete the installation of this appliance. This downdraft blower system is designed to be used
7Plan the DuctworkThis downdraft blower system is designed for use with 3¼ x 10” ductwork (can be transitioned to 6” round).For best performance, choo
8Plan the Electrical ConnectionThe downdraft blower system draws 2.8 AMPS and requires a 120 VAC, 60 Hz circuit.The unit has a 28 inches long power co
91. Cut Countertop Opening- Lay out and cut the cooktop cut-out far enough forward so downdraft will t behind it (refer to cooktop installation instr
Comments to this Manuals