Frigidaire FKGD30ANLW User Manual download pdf (Page 21)

If you have any doubt, please contact

a qualified person.

Do not modify your gas range plug.

Do not bite, twist or tie the power

cord.

It is dangerous to modify the range

specifications or features.

01. Before turning on the range,

check to see if the voltage of

the outlet to be used is the

same as that indicated on the

tag located close to the plug

(along the power cord) or on

the gas range identification

label.

02. Install the ground cable or your

gas range according to your

local requirements.

03. If you need to modify the

electric installation, this should

be performed by qualified

personnel.

04. Be sure that electric plug is

easy to reach after installation.

05. Power cord should never be in

contact with hot parts of the

gas range, because the plastic

protection might melt causing a

short circuit.

06. Connect the range to its own

outlet. Do not use an extension

cord or adaptor plug.

07. Never ground the appliance on

PVC or gas pipes.

08. Be sure that the power cord

does not goes through the

back of the gas range.

Electric installation

For your safety, check the electric conditions of the place where the gas range

will be installed by a qualify electrician or contact an authorize service.

39 40

2 cm

80 to 85 cm

between the top of the gas range and

any cabinet or range hood install

above the product. This gas range

is not prepared to be installed built

in.

06. Leave enought room between the

back of the oven and the wall, to

allow for opening the cover.

07. If the oven is installed next to a

wooden wall, please place a fire-

resistant panel next to the wall and

ensure that the oven is more than

4 cm from the wall. Please place

1pc fire-resistant panel (lenght and

a high degree are more than 4 cm

than the oven ) between the wall

and the oven, if the oven will be

installed on wooden wall.

08. Make sure not to block the oven

gas exit, including the funnel or the

gas vents, when you install the

oven.

The guarantee does not cover the

problems caused by defective

installations or changes that were

performed by non-qualified

personnel.

ENG

Attention

Backsplash assembling (only in

some models)

1. Unscrew the screws from the

cooktop support and cooktop.

2. Align the holes on the cooktop

support and backsplash with

cooktop holes.

3. Fix screws.

4. Ensure backsplash is correctly and

securely fixed.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 32 33

Comments to this Manuals

No comments

Frigidaire FKGD30ANLW User Manual Page 21

Comments to this Manuals