Frigidaire FAD954DWD Owner's Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 11
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
Operating Instructions
Operating Instructions
4
2009 Electrolux Home Products, Inc. All rights reserved.
Allow the unit to reach room temperature before operating.
To begin operating the dehumidifier, follow these steps:
1. Plug the power cord into a properly grounded 115 volt AC outlet.
If the "BUCKET FULL" light is on, remove the bucket and re-install to reset the float switch.
NOTE:
Unit must be upright for one hour prior to operating.
NOTE:
2.
LOW
LOCK
TIMER
CLEAN FILTER
MEDIUM
HIGH
POWER
CONTINUOUS
BASEMENT
LIVING SPACE
SLEEPING SPACE
BUCKET FULL
FILTER
TIMER
FAN
MODE
CONTI
NUOUS
SPEED
_
+
LOW
LOCK
TIMER
CLEAN FILTER
MEDIUM
HIGH
POWER
CONTINUOUS
BASEMENT
LIVING SPACE
SLEEPING SPACE
BUCKET FULL
FILTER
TIMER
FAN
MODE
CONTI
NUOUS
SPEED
_
+
65
3. After a few days when the Relative Humidity has declined, press the HUMIDITY or buttons to choose a value
between 35% to 80%, so the room is kept at a comfortable humidity. Pressing the or buttons will change the
humidity selection in 5% increments. After you have set the desired humidity, the readout will display the actual
room humidity.
LC
LOW
LOCK
TIMER
CLEAN FILTER
MEDIUM
HIGH
POWER
CONTINUOUS
BASEMENT
LIVING SPACE
SLEEPING SPACE
BUCKET FULL
FILTER
TIMER
FAN
MODE
CONTI
NUOUS
SPEED
_
+
+-
+-
To turn the unit on, press the ON/OFF button. The unit will run in the factory setting of CONTINUOUS and high fan
speed. In the CONTINUOUS mode, the unit will display the actual room humidity. It is recommended you leave the
unit running in the CONTINUOUS setting for the first three or four days until the sweating and dampness odors have
stopped.
When unit is in operation, pressing and button will simultaneously for 3 seconds can lock buttons. If this function is
enabled, LOCK indicator will illuminate and display shows LC, which will blink for 3 times. Then room humidity will be display
again. To disable this function, press and button simultaneously for 3 seconds and the LOCK indicator will turn off.
+-
+-
Page view 3
1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments