Frigidaire FFHN2740PE Owner's Manual download pdf (Page 6)

6

INSTALLATION

Toe Grille Must

Fit in Slot on

Anti-tip Bracket

Screw/Washer

Assembly

(3) Retaining Clips

Leveling Freezer Drawer

(if necessary)

To level the cabinet using the front

rollers (select models):

1 Slightly open freezer drawer. Lift the

toe grille and gently pull forward (see

illustration).

 2 Youcanraiseorlowereachdoor.Usea⅜

inch socket wrench to turn the adjustment

screws (one per side).

1 Check gasket seal around top, bottom,

and sides of freezer drawer.

2 If gasket is not sealed, open drawer and

slightly loosen four drawer screws (two on

each side) to allow drawer to rotate.

3 Close drawer and recheck the seal on the

gasket (A). Open the drawer grabbing by

the sides in the center (B). Be careful not

to rotate the drawer.

4 Tighten four drawer screws.

5 Recheck gasket seal.

Push

Against

Freezer

Drawer

Grab Drawer

At Center

From Both

Sides Then

Pull Drawer

Out

A B

Remove Hex

Head Drawer

Screw

Remove Hex

Head Drawer

Screw

Do Not Remove

Other Screws

Do Not Remove

Other Screws

Remove Hex

Head Drawer

Screw

Remove Hex

Head Drawer

Screw

Raise

Lower

Anti-tip

Leg

Door

Door

 5 Installthetoegrillebyttingintoplace.

Level Refrigerator & Adjust Doors

(if necessary)

Guidelines for nal positioning of your

refrigerator:

• All four corners of the cabinet must rest

rmlyontheoor.

• The sides should tilt ¼ inch (6 mm) from

front to back (to ensure that doors close

and seal properly).

• Doors should align with each other and be

level.

Most of these conditions can be met by raising

or lowering the adjustable front rollers.

To raise: turn adjustment screw clockwise.

To lower: turn adjustment screw

counterclockwise.

3 Ensure both doors are bind-free with their

seals touching the cabinet on all four sides

and that cabinet is stable.

4 After unit is leveled, lower anti-tip leg until

itcontactstheoor.

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Comments to this Manuals

No comments