Frigidaire FFPA0822T1 Use and Care Manual download pdf (Page 7)

Installation Instructions

Installation Instructions(continued)

1.Cut the foam seals A(adhesive type) to the proper lengths and attach

them to the window and stool.(Fig.8)

2.Open the window sash and place the window slider kit on the window

stool (Fig.9). Attach the window slider kit to the window stool. Adjust

the length of the window slider kit according to the width of window.

Screw down the two screws on the window slider kit. See Fig.9.

Cut the adjustable window slider kit if the width of window is less than

26.6 inches(Fig.10).

3.Close the window sash securely against the window slider kit.(Fig.11)

4.Drive two 1 / 2″ screws to secure the window slider kit to the window

sash.(Fig.11)

5.Secure the window slider kit to the window stool(Fig.11):

A: For wooden window: Use 3 / 4″ screws for securing.

B: For Vinyl-Clad windows: Use 1 / 2″ hex head cap screws for

securing.

6.To secure lower sash in place, attach right angle sash lock with 1 / 2″

(12.7mm) screw as shown(Fig.12).

NOTE: It is difficult to lock the windows with the sash lock for Vinyl-Clad

windows, so you can use lock by window itself.

7.Cut the foam seal B to an appropriate length and seal the open gap

between the top window sash and outer window sash, as shown in

Fig.13.

Installation in a double-hung sash window

Installation in a sliding sash window

1.Cut the foam seals A(adhesive type) to the proper lengths and attach

them to the window frame. See Fig.14.

2.Open the window sash and place the window slider kit on the window

stool (Fig.15). Attach the window slider kit to the window stool. Adjust

the length of the window slider kit according to the height of window.

Screw down the two screws on the window slider kit. See Fig.15.

Cut the adjustable window slider kit if the height of window is less than

26.6 inches(Fig.10).

3.Close the window sash securely against the window slider kit.(Fig.16)

4.Drive two 1 / 2″ screws to secure the window slider kit to the window

sash.(Fig.16)

5.Drive two 3 / 4″ screws to secure the window slider kit to the window

stool.(Fig.16)

6.Cut the foam seal B to an appropriate length and seal the open gap

between the sliding sash and outer window sash, as shown in Fig.17.

7.To secure sliding sash in place, attach right angle sash lock with 1 / 2″

(12.7mm) screw as shown(Fig.18).

Fig.8

Fig.9

Fig.10

Fig.14

Fig.15

Fig.16

Fig.17

Fig.18

Fig.11

Fig.12

Fig.13

screws

screws or

hex head cap screws

Window stool

Window slider kit

Foam seal B

Foam seal A

(adhesive type)

screws

Window slider kit

Window stool

Cut this to fit your window

Foam seal A

(adhesive type)

Window stool

Window slider kit

screws

Window stool

Window slider kit

screws

Foam seal B

screws

1 2 3 4 5 6 7 8 ... 20

Comments to this Manuals

No comments

Frigidaire FFPA0822T1 Use and Care Manual Page 7

Comments to this Manuals

Related products and manuals for Unknown Frigidaire FFPA0822T1