Frigidaire FFRE0533S1 Wiring Diagram download pdf

READ BEFORE INSTALLING UNIT

OPP Window Mounting (5,000~6,500 BTU)

Installation Instructions

Before installing, the top rail must be assembled on the unit.

Top Rail Hardware

Qty.

3/8Ǝ Screw

Top Rail

Some assembly is required. Please read these instructions

carefully.

DO NOT USE ANY SCREWS OTHER THAN

THOSE SPECIFIED HERE.

NOTE:

SAVE CARTON and these INSTALLATION

INSTRUCTIONS for future reference. The carton is

the best way to store unit during winter, or when not

in use.

FOR SAFETY REASONS, THE TOP RAIL MUST BE

SECURELY FASTENED WITH ALL FOUR (4)

SCREWS.

A. Remove the air conditioner from the carton and place on a flat surface.

B. Remove top rail from the rear of the packaging material as shown in Fig. A

C. Align the hole in the top rail with those on the top of the unit as shown in Fig. B

D. Secure the top rail to the unit with the 3/8Ǝ Screws as shown in Fig. C

Fig. B

Packaging

Top Rail

Fig. A

16120300A04631

Fig. C

Pay attention to danger and safety notices.

To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may

be exposed:

Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install

the unit. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp metal fins of front and rear coils. To

prevent injury or strain, use proper lifting and carrying techniques when moving unit.

Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit overan extended

period of time.

Handle air conditioner with care.

Make sure air conditioner does not fall during installation.

Carefully read the installation manual before beginning.

Follow each step as shown.

Observe all local, state, and national electrical codes and by qualified, licensed, authorized personnel only.

INSTALLATION WARNINGS AND CAUTION

Drill (If pilot holes are needed)

Mounting Hardware

Qty.

( or Wooden windows)

weather stripping

insulation panel

ruler

(10”X3/4”X1/12”)

window sash seal foam 1

1 2 3 4 5

Summary of Contents

Page 1 - Installation Instructions

READ BEFORE INSTALLING UNITOPP Window Mounting (5,000~6,500 BTU)1Installation InstructionsBefore installing, the top rail must be assembled on the uni

Page 2 - How to Install

How to InstallNOTE: Top Rail and Side Panels at each side are offset to provide the proper pitch to the rear of (5/16”). This is necessary for proper

Page 3 - Installation

How to InstallInstallationExtend the side panels out against the window frame (FIG. 7A for wooden windows), (FIG. 7B for Vinyl-Cladwindows).FIG. 7Awi

Page 4 - FIG. 11 FIG. 12

4InstallationFIG. 13FIG. 14FOAM SEAL Cut foam window seal and insert it into the space between the upper and lower sashes (FIG. 14).NOTE:

Page 5

InstallationRemoving the air conditioner From WindowTurn the air conditioner off, and disconnect power cord.Remove sash seal from between windows, and