Frigidaire FFRE1001PW Specifications Sheet download pdf (Page 3)

Specifications

subject to change.

Specifications

subject to change.

USA

•

10200 David Taylor Drive

•

Charlotte, NC 28262

•

1-800-FRIGIDAIRE

•

frigidaire.com

CANADA

•

5855 Terry Fox Way

•

Mississauga, ON L5V 3E4

•

1-800-265-8352

•

frigidaire.ca

Dryer

FFRE1001PW 7.0 Cu. Ft. D.O.E. Electric

• Do NOT install in area exposed to dripping water or outdoor weather

conditions; where gasoline or other flammables are kept or stored; or

where dryer comes in contact with curtains, drapes or anything that

will obstruct flow of combustion and ventilation air.

• For garage installation, dryer MUST be located minimum 18" above floor.

• Floor MUST be solid with 1" maximum slope. Do NOT install on

carpeted surface.

• Dryer MUST exhaust to outside of building, NOT into any concealed

space.

• Exhaust installation requires minimum 4"-diameter rigid or semi-rigid

metal duct with approved, unobstructed vent hood having swing-out

damper(s). If installing rigid metal duct (preferred), do not exceed

MAXIMUM venting run length of 64 ft., allow deductions for elbows

and vents. If installing semi-rigid metal duct, do not exceed MAXIMUM

venting run length of 8 ft., always allow deductions for elbows and

vents. (Refer to Product Installation Guide on web for additional

information.) Do NOT use flexible plastic or metal foil duct and use

shortest run possible.

• Leveling legs supplied to level dryer properly and reduce excessive

noise and vibration.

• For manufactured or mobile home installation optional Mobile Home

Installation Kit (PN # 137067200) required. (For specific installation

details, refer to Product Installation Guide on web.)

Note: For planning purposes only. Refer to Product Installation Guide

on the web at frigidaire.com for detailed instructions.

Optional Accessories

• Mobile Home Installation Kit – (PN # 137067200).

• Drying Rack – (PN # 137067300).

Top Load Dryer Specifications

• Product Shipping Weight (approx.) – 143 Lbs.

• Designed for HOME USE only, not recommended for commercial

application.

• An electrical supply with grounded three-prong receptacle is required.

• Voltage Rating – 240V / 60 Hz / 30 Amps

• Single phase 3- or 4-wire cable, 240 Volt, 60 Hertz AC only electrical

supply with ground required on separate circuit fused on both sides

of line. (Do not use same circuit as washer.)

• Connected Load (kW Rating) @ 240 Volts = 5.4 kW

• Amps @ 240 Volts = 24 Amps

• Dryer MUST employ a 3-conductor NEMA 10-30 type SRDT or

4-conductor NEMA 14-30 type SRDT or ST (as required), rated at

240 volt AC minimum, 30 amp power supply cord marked for

use with clothes dryers (not supplied).

• Grounding through neutral link prohibited in specific applications and

certain locales, requiring use of 4-wire system. (For detailed electrical

requirements, refer to Product Installation Guide on web.)

• Always consult local and national electric codes.

• Dryer can be installed in recess or closet requiring 0" minimum

installation clearance around sides and back of unit. To achieve

0" minimum rear clearance, dryer MUST be vented straight back.

Closet installation requires additional 1" minimum clearance between

front of unit and vented door. Door MUST be vented with 120 sq. in.

minimum louvered opening, equally divided, located 3" from top and

bottom of door. A louvered door with equivalent air openings for full-

length of door is acceptable. Air openings MUST remain unobstructed

with door installed. (For additional installation details, refer to Product

Installation Guide on web.)

Top Load Laundry - Electric Dryer

Frigidaire Baseline (P Model)

Recess or Closet Installation

Dryer requires 0" minimum installation clearance

around sides and back of unit. To achieve 0"

minimum

rear clearance, dryer MUST be vented straight back.

Closet installation requires additional 1"

minimum

clearance between front of unit and vented door. Door

MUST be vented with 120 sq.

in. minimum louvered

opening, equally divided, located 3" from top and

bottom of door. A louvered door with equivalent air

openings for full-length of door is acceptable.

Air openings MUST remain unobstructed with door

installed. For additional installation details, refer to

Product Installation Guide on web.

29"

50"

Side

Reversible

Door Swing

Vented door

min. 1"

min.

Side

60"

sq.

in.

min.

60"

sq.

in.

min.

min. 0"

min.

23"

min.

Front

27"

/2"

Front

/2"

/4"

Rear

vent

240V Power

supply (rear)

1 2 3

Comments to this Manuals

No comments

Frigidaire FFRE1001PW Specifications Sheet Page 3

Comments to this Manuals

Related products and manuals for Washer dryers Frigidaire FFRE1001PW