Frigidaire FFHT10F2LW User Manual download pdf (Page 4)



nOtE

The exterior walls of the refrigerator may become quite

warm as the compressor works to transfer heat from

the inside. Temperatures as much as 30° F warmer

than room temperature can be expected. For this

reason it is particularly important in hotter climates

to allow enough space for air circulation around your

refrigerator.

Leveling

The refrigerator must have all bottom corners resting

rmly on solid oor. The oor must be strong enough

to support a fully loaded refrigerator. NOTE: It is Very

Important for your refrigerator to be level in order to

function properly. If the refrigerator is not leveled during

installation, the door may be misaligned and not close

or seal properly, causing cooling, frost, or moisture

problems.

To Level Your Refrigerator:

After removing all interior and exterior packaging

materials, and after discarding crating screws and wood

base, use a carpenter’s level to level the refrigerator from

front-to-back. Adjust the plastic leveling feet in front, ½

bubble higher, so that the door closes easily when left

halfway open. from front-to-back. Adjust the leveling

legs in front, ½ bubble higher, so that the door closes

easily when left halfway open.

Cleaning

Wash any removable parts of the refrigerator •

interior, and exterior with mild detergent and warm

water. Wipe dry. Do not use harsh cleaners on these

surfaces.

Do not use razor blades or other sharp instruments, •

which can scratch the appliance surface when

removing adhesive labels. Any glue left from the tape

can be removed with a mixture of warm water and

mild detergent, or touch the residue with the sticky

side of tape already removed. Do not remove the

serial plate.

Install the refrigerator in the coolest part of a dry •

and ventilated room, out of direct sunlight and away

from heating ducts or registers. Do not place the

refrigerator next to heat-producing appliances such

as a range, oven or dishwasher.

Level the refrigerator so the door close tightly.•

Do not overcrowd the refrigerator or block cold air •

vents. Doing so causes the refrigerator to run longer

and use more energy. Shelves should not be lined

with aluminum foil, wax paper or paper toweling.

Liners interfere with cold air circulation, making the

wine cooler less efcient.

Wipe bottles and containers dry before placing them •

in the refrigerator. This cuts down on moisture build-

up inside the unit.

Organize the refrigerator to reduce door openings. •

Remove as many items as needed at one time and

close the door as soon as possible.

InStALLAtIOn

This Use & Care Guide provides general operating

instructions for your model. Use the refrigerator only as

instructed in this Use & Care Guide. Before starting the

refrigerator, follow these important rst steps.

Location

Choose a place that is near a grounded electrical •

outlet. Do Not use an extension cord or an adapter

plug.

For the most efcient operation, the refrigerator •

should be located where surrounding temperatures

will not drop below 10° F (-12° C) or exceed 110°

F (43° C). The Freeze Control Feature is designed

to automatically maintain the selected interior

refrigerator temperature within these boundaries.

Allow space around the unit for good air circulation. •

Leave a 5 inch (50 mm) space on the back and

the sides, and 12 inches (300 mm) above the

refrigerator for adequate circulation.

cAutIOn

To allow door to close and seal properly, DO NOT let

food packages extend past the front of shelves.

ENERGY SAVING TIPS

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Frigidaire FFHT10F2LW User Manual Page 4

Comments to this Manuals

Related products and manuals for Drink coolers Frigidaire FFHT10F2LW