Frigidaire FGEF302TPF Use and Care Manual download pdf (Page 7)

BEFORE SETTING SURFACE CONTROLS

Fig. 1

Fig. 5

Fig. 8

Fig. 9

Fig. 11

Fig. 6 Fig. 7

Fig. 2 Fig. 3 Fig. 4

COOKTOP DISPLAY WINDOWS

The cooktop controls provide a digital display for each

element located on the cooktop. Power levels and

messages are easily monitored and adjusted using the

corresponding control keypads in combination with the

window displays.

HOT ELEMENT INDICATOR MESSAGE (HE)

After using any of the radiant element

positions the cooktop will become very hot. Even after

turning the element OFF, the cooktop will remain hot for

some time and burns may occur if surface is touched.

The control monitors the temperature of the cooktop and

displays the message “HE” (hot element) warning when

the cooktop is still too hot to touch (Figure 8). If the HE

message appears in the window, the control can still be

turned on again for use.

POWER FAILURE (PF) MESSAGE

The PF message (Figure 9) will be displayed whenever

there has been a power interruption to the appliance.

The PF message will disappear by itself after a few

seconds.

SABBATH FEATURE (SB) MESSAGE

The cooktop display windows will show the Sb message

whenever the Sabbath feature is active (Figure 11).

When activated, the Sabbath feature works for both the

oven and cooktop together. Once the Sabbath feature is

active, changes to the heat levels for the cooktop heating

elements will not show in the displays. The cooktop

will react slower to heat level changes. See Sabbath

feature section for complete instructions.

Fig. 10

COOKTOP LOCKOUT (--)

The cooktop lockout (--) message will appear in the

cooktop display windows whenever the Lockout feature

is active or during a self clean (See Fig. 10). The cooktop

will remain locked until the Flex Clean cycle is ﬁ nished

and the oven door has unlocked or until the Lockout

feature is deactivated.

THE AVAILABLE POWER LEVEL SETTINGS

The cooktop control will display heat levels ranging

from Hi (Figure 1) to Lo (Figure 6) and OFF (Figure 7).

The settings between 9.5 (Figure 2) and 3.0 (Figure

3) decrease or increase in increments of .5 (1/2). The

settings between 2.8 (Figure 4) and 1.2 (Figure 5) are

Simmer settings which decrease or increase in increments

of .2 (1/5) to Lo (Figure 6; lowest Simmer setting) for

more precise settings at lower heat levels.

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Comments to this Manuals

No comments

Frigidaire FGEF302TPF Use and Care Manual Page 7

Comments to this Manuals

Related products and manuals for Microwaves Frigidaire FGEF302TPF