Frigidaire IM116000 Installation Guide download pdf (Page 4)

9. Push tube seal (12) over threads (Figure 5). Push

plastic water supply tubing (3) into water inlet tube (11)

as far as it will go and nger tighten nylon compression

nut onto threaded end of inlet tube. Tighten another ½

turn with a wrench. DO NOT over-tighten.

10. Push water inlet tube (11) through small hole where

Installation label was (Figure 6). Rotate while inserting

tube until at surface of inlet tube is tight against back

of refrigerator.

11. Install adjustable leveling bracket (7) on bottom of Ice

Maker (1) with screw (6) (Figure 7). DO NOT tighten

bracket. It will be tightened later in this procedure.

12. Start two, long, Ice Maker mounting screws (5) into

freezer wall where plugs were removed in Step 4. Turn

each screw clockwise ve turns (Figure 8).

13. Connect wiring harness into connector mounted on the

back freezer panel, just to the left of where the water inlet

tube comes through. The harness connector is keyed so it

will only t one way. Next, slide Ice Maker connector cover

over connector, noting the orientation in Figure 9. (Snap

on top, hook on bottom). The Ice maker connector cover

can then be snapped into place into the back panel or

slid up tight to back panel depending on which version of

back panel you have (see note below). Then, mount Ice

Maker to the two screws (5) you started earlier from Step

12. (See gure 10.) Tighten screws. Make sure water inlet

tube (11) is sitting inside ll cup.



NOTE

It requires the use of both hands to hook up and secure

the Ice Maker to the freezer wall. DO NOT let the Ice

Maker dangle free after the wiring harness is plugged

into the connector on the back freezer wall.

of Ice Maker (1) with screw (6). DO NOT tighten

bracket. It will be tightened later in this procedure.

Figure 7

Ice Maker

Connector

Cover

Wire

Harness

Connector

Cover Slides

Forward

Snap

Hook

Snap

Figure 9

Figure 6

Leveling

Bracket (7)

Screw (6)

Figure 7

(5) Ice Maker

Mount Screws

Figure 8

(11) Water Inlet

Tube

(3) Water

Tubing

(12) Tube Seal

Figure 5



NOTE

If your back

cover looks like

(A) proceed to

installing ice maker.

If your back cover

looks like (B),

break off snap and

hook on connector

cover using pliers,

then proceed to

installing ice maker.

Back Covers

A B

1 2 3 4 5 6 7 8 9 ... 23 24

Comments to this Manuals

No comments

Frigidaire IM116000 Installation Guide Page 4

Comments to this Manuals

Related products and manuals for Sanitary ware Frigidaire IM116000