Frigidaire FFBC4622QS Use and Care Manual download pdf (Page 4)



nOtE

The exterior walls of the beverage cooler may become

quite warm as the compressor works to transfer heat

from the inside. Temperatures as much as 30° F

warmer than room temperature can be expected. For

this reason it is particularly important in hotter climates

to allow enough space for air circulation around your

appliance.

    

The beverage cooler must have all bottom corners resting

rmly on solid oor. The oor must be strong enough

to support a fully loaded beverage cooler. nOtE: It is

Very Important for your appliance to be level in order to

function properly. If the appliance is not leveled during

installation, the door may be misaligned and not close

or seal properly, causing cooling, frost, or moisture

problems.



After removing all interior and exterior packaging

materials, use a carpenter’s level to level the beverage

cooler from front-to-back. Adjust the leveling legs in

front, ½ bubble higher, so that the door closes easily

when left halfway open.



Wash any removable parts of the beverage cooler 

interior, and exterior with mild detergent and warm

water. Wipe dry. Do not use harsh cleaners on these

surfaces.

Do not use razor blades or other sharp instruments, 

which can scratch the appliance surface when

removing adhesive labels. Any glue left from the tape

can be removed with a mixture of warm water and

mild detergent, or touch the residue with the sticky

side of tape already removed. Do not remove the

serial plate.

 Do not store food in your wine

cooler as interior temperature may not get cool enough

to prevent spoilage. In summer months or areas of high

humidity, the glass door may build up moisture. To

remove the moisture, wipe it away.



Place handle over the two mounting studs located at 

top of door.

Use hex head screw driver or Allen wrench to tighten 

set screws from bottom to secure handle to door.

� Handle

ĸ Wooden Shelf Made of Beech

Ĺ Control Panel

� Glass Door

� Control Switch of Lamp

� Adjustable Leg

Placement of Wine Cooler

The wine cooler should be placed in dry and ventilated room. The location of

the wine cooler should not be irradiated by direct sunshine. The wine cooler

should be far away from heating sources, such as: cooking stove or heating

radiator. If the wine cooler has to be placed near heating source, please adopt

proper heating insulation board for insulation or keep the wine cooler at least

the following minimum distances away from the heating sources:

For electric stove: 3 ΁.

For oil or coal stove: 30 ΁.

Replacement of Door Hinge

The door hinges of this wine cooler can be interchanged between the left and

right sides.

Installation of Handle

1. Set the handle on the fixation shaft.

Fixation Shaft of Handle

Set Handle

2. Screw down the fixation pins of the handle with screw driver.

- 7 -

Mounting stud

Locate handle

Set screws

InStALLAtIOn

This Use & Care Guide provides general operating

instructions for your model. Use the appliance only as

instructed in this Use & Care Guide. 





Choose a place that is near a grounded electrical •

outlet.  use an extension cord or an adapter

plug.

For optimal performance, it is recommended •

that you install the appliance where the ambient

temperature is between 70 and 78 degrees

Fahrenheit.

Allow space around the unit for good air circulation. •

Leave a 2 inch space on the back and sides of the

wine cooler for adequate circulation.

Be sure the appliance stays in the upright position •

during transport.

Keep the appliance from any hazardous or •

combustible agents.

1 2 3 4 5 6 7 8 9 ... 34 35

Comments to this Manuals

No comments

Frigidaire FFBC4622QS Use and Care Manual Page 4

Comments to this Manuals

Related products and manuals for Wine coolers Frigidaire FFBC4622QS