Frigidaire FFEH3054US Installation Manual download pdf (Page 4)

30” ELECTRIC FRONT CONTROL FREESTANDING INSTALLATION INSTRUCTIONS

C. Level and Position Range - Level range by adjusting the

(4) leveling legs with a wrench. Note: Aminimum clearance

of 1/8” (3 mm) is required between the bottom of the

range and the leveling leg to allow room for the bracket.

Use a spirit level to check your adjustments. Slide range

back into position. Visually check that rear leveling leg

is inserted into and fully secured by the Anti-Tip Bracket

by removing lower panel or storage drawer. For models

with a warmer drawer or broiler compartment, grasp the

top rear edge of the range and carefully attempt to tilt it

forward.

3. Electrical Connection

Requirements

Avoid re hazard or electrical shock. Failure

to follow this warning may casue serious injury, re, or death.

This appliance must be properly installed and grounded

by a qualied technician in accordance with the National

Electrical Code ANSI/NFPA No. 70 -- latest edition -- and

Local Electrical Code requirements.

This appliance may be connected by means of “permanent

wiring” or power supply cord kit.”

When installing permanent wiring, do not leave excess

wire in range compartment. Excess wire in the range

compartment may not allow the rear access cover to be

replaced properly and could create a potential electrical

hazard if wires become pinched. Connect only as

instructed under “Permanent Wire Connections” in Step

4c. When using exible conduit or range cable use ex

connector or range cable strain relief

Models requiring power supply cord

kit

RISK OF FIRE OR ELECTRICAL SHOCK MAY OCCUR IF

AN INCORRECT SIZE RANGE CORD KIT IS USED, THE

INSTALLATION INSTRUCTIONS ARE NOT FOLLOWED

OR STRAIN RELIEF BRACKET IS DISCARDED.

This appliance may be connected by means of a power

supply cord. Only a power supply cord kit rated at 125/250

volts minimum, and marked for use with ranges shall be

used. See Fig. 10 for cord kit ampere rating information.

Cord must have either three (3) or four (4) conductors (See

Fig. 8). Terminals on end of wires must be either closed

loop or open-end spade lugs with upturned ends. Cord

must have strain relief properly installed. See Steps 4a. for

4-Wire or 4b. for 3-Wire connections.

Fig.7

(17 mm)

1 2 3 4 5 6 7 8 9 ... 15 16

Comments to this Manuals

No comments

Frigidaire FFEH3054US Installation Manual Page 4

Comments to this Manuals

Related products and manuals for Baby furniture Frigidaire FFEH3054US