Frigidaire FFEH3054US Installation Manual download pdf (Page 6)

30” ELECTRIC FRONT CONTROL FREESTANDING INSTALLATION INSTRUCTIONS

4B. POWER CORD CONNECTIONS

(3-Wire Connection Instructions

For existing installations ONLY - Refer

to Fig. 13).

1. Follow the manufacturer’s installation instructions

supplied with the strain relief and install (Also see Figs.

9, 10 & 11).

2. Insert the end connectors for Line 1, Line 2 and

Neutral and tighten securely to the terminal block (See

Fig. 13).

IMPORTANT NOTE: DO NOT LOOSEN the factory

installed nut connections which secure the range

wiring to the terminal block. Electrical failure or loss

of electrical connection may occur if these 3 nuts are

loosened or removed.

3. Make sure all connections are tightened securely and

replace the rear access cover (See Fig. 9).

Grounding Instructions (3-Wire

Connections only)

A ground strap is installed on this range which connects

the center terminal of the terminal block (Neutral) to the

range chassis. The ground strap is connected to the range

by the center, lowest screw (See Fig. 13). The ground

strap must not be removed unless National, State or Local

Codes do not permit use of a ground strap.

NOTE: If the ground strap is removed for any reason, a

separate ground wire must be connected to the separate

ground screw attached to the range chassis and to an

adequate ground source.

Fig. 13

NOTE: Internal

white wire not

present on all

models.

4A. POWER CORD CONNECTIONS

(4-Wire Connection Instructions - Refer

to Fig.12)

Before wiring the range review the suggested power

source location drawing in Fig. 3. If connecting to a 4-Wire

electrical system (new branch-circuit or mobile home

requires 4-Wire connection):

1. Follow the manufacturer’s installation instructions

supplied with the strain relief and install (Also see Figs.

9, 10 & 11).

2. Insert the end connectors for Line 1, Line 2 and

Neutral and tighten securely to the terminal block.

IMPORTANT NOTE: DO NOT LOOSEN the factory

installed nut connections which secure the range

wiring to the terminal block. Electrical failure or loss

of electrical connection may occur if these 3 nuts are

loosened or removed.

3. You must disconnect the ground strap. Remove the

factory installed ground screw & plate to release the

copper ground strap from the frame of the appliance.

Cut and discard the copper ground strap & plate.

KEEP the ground screw.

4. Connect the ground wire (Green) lead with the eyelet

to the frame of the appliance with the ground screw

using the same hole in the frame where the ground

screw was originally installed (See Fig. 12).

5. Make sure all screws are tightened securely and

replace the rear access cover (See Fig. 9).

Fig. 12

NOTE: Internal

white wire not

present on all

models.

Fig. 13

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments

Frigidaire FFEH3054US Installation Manual Page 6

Comments to this Manuals

Related products and manuals for Baby furniture Frigidaire FFEH3054US