Frigidaire FFTW4120SW Installation Manual download pdf (Page 9)

Connecting drain and electrical

1 Snap one end of the drain hose hanger (shipped in

washer drum) onto the drain hose. Continue wrapping

it around the hanger and snap it in place.

2 Place the hook end of the drain hose in the drain

opening. Secure the drain hose with the cable tie

(provided in the enclosure package) to the standpipe,

inlet hose, laundry tub, etc. so the hose does not pull

out from the force of the water.

3 Plug the power cord into a grounded outlet.

4 Turn on the power at the circuit breaker/fuse box.

5 Carefully slide the washer to its ﬁ nal position. Recheck

for level and rock corners for stability.

6 Read the

Use & Care Guide

provided with the washer. It

contains valuable and helpful information that will save

you time and money.

7 Run the washer through a complete cycle, checking for

water leaks and proper operation.

8 If you have any questions during initial operation,

please review the “Avoid Service Checklist” in your Use

& Care Guide before calling for service.

9 Place these instructions in a location near the appliance

for future reference.

Grounding type

ll receptacl

ll receptacle

wer cord with

3-prong

ounded plug

Do not,

under

y cir

cumstances,

cut,

remo

ve,

or b

ypass th

ypass the

ounding pr

ong.

IMPORTANT

Check to ensure the power is off at a circuit breaker/fuse

box before plugging the power cord into an outlet.

NOTE

The standpipe inside diameter must be 1-1/4” (3.2 cm)

minimum. There must be an air gap around the drain hose

in the standpipe. A snug hose ﬁ t can cause a siphoning

action.

INSTALLATION INSTRUCTIONS

CABLE TIE

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments

Frigidaire FFTW4120SW Installation Manual Page 9

Comments to this Manuals