Frigidaire FKGD30ANLW User Manual download pdf (Page 22)

41 42

Hose installation

01. Place the metal clamp on the hose end.

02. Connect the hose to the oven connector and tighten the clamp.

03. Place the other clamp on the opposite hose end and connect it to the

pressure regulator. Tighten the clamp.

04. Bolt the pressure regulator to the gas cylinder carefully.

05. After installation, check if there is any gas leak, using soap or liquid

detergent foam

Plastic Hose

If you have any doubt or need to buy

any accessory for the installation,

please contact our authorize service.

Pressure regulator

Metalic flexible tube

Gas installation

01. This range was designed for

use with LP or NG gas. Check

the product label to verify the

gas type the manufacturer has

calibrated it with.

02. Always use a pressure

regulator exclusive for your gas

range. The lack of pressure

regulator might cause excess

of pressure and leak of gas.

Always check for the validity of

the pressure regulator. Hose

and regulator should be

replaced every 5 years.

Technical specification of the

pressure regulator:

• Pressure: 200 mm C. A.

• Max. consumption: 2 kg/h

03. Always use a PVC hose to

work from -20ºC to 100ºC. Be

sure that hose:

• does not have joins.

• does not go on the back of

the gas range neither close

to the hot air exits.

• its less than 125cm long.

04. If possible, install the gas

cylinder outside the kitchen, in

a place protected and with air

flow.

05. Use a 1/2"metallic hose to

connect to the gas range using

a L coupling connector.

06. Only use a plastic hose when

this one does not go on the

back of the gas range.

ENG

L coupling

connector

Connector

Attention

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 32 33

Comments to this Manuals

No comments

Frigidaire FKGD30ANLW User Manual Page 22

Comments to this Manuals