Frigidaire FFGF3056TW Owner's Manual download pdf (Page 36)

CARE AND CLEANING

6. Wipe the burner head clean with a soft, clean cloth,

sponge, or scratch-free cleaning pad.

7. Before using the cooktop again, make sure the burner

caps are properly placed and seated on the burner

heads. When placed correctly, the burner cap is

centered on the burner head and will click into place on

the burner head. You can wiggle the cap to test place

ment, it should not move off the burner head (see

“Assembly of the burner caps” on page 13).

Important notes:

• The surface burner heads are secured to the cooktop

and must be cleaned in place on the cooktop.

• Always keep the surface burner caps in place whenever

a surface burner is in use.

• When replacing the burner caps, be sure the burner

caps are seated firmly on top of the burner heads.

• For proper flow of gas and ignition of burners do not

allow spills, food, cleaning agents, or any other material

to enter the gas orifice port opening.

Replacing the Oven Light

Replacing the oven interior light bulb:

The interior oven light is located at the rear of the oven

cavity and covered with a glass shield. The glass shield

must be in place whenever the oven is in use (

Figure 27).

1. Turn electrical power off at the main source or unplug

the appliance.

2. Remove the interior oven light shield after removing the

wire holder by carefully moving the wire to the side of

the glass shield. The tension from the wire holds the

glass shield in place.

3. Pull the shield straight out. Do not twist or turn.

4. Replace the bulb with a new appliance bulb.

5. Replace the glass oven light shield. Replace wire

holder.

6. Turn the power back on again at the main source (or

plug the appliance back in).

7. Be sure to reset the time of day on the clock.

To remove and replace storage drawer (some

models)

Use the storage drawer for storing cooking utensils. The

drawer can be removed to facilitate cleaning under the

range. Use care when handling the drawer.

To remove the drawer:

1. Pull empty drawer out until it stops.

2. Tilt up the front of the drawer up and pull it out over the

glide stop.

To replace the drawer:

1. Insert the back of the drawer into the opening.

2. Lift up the drawer and line up the drawer supports with

the rails. Make sure to clear the glide stop.

3. Push in the drawer until it stops.

Be sure the oven is unplugged and all parts are cool

before replacing the oven light.

CAUTION

Figure 27: Oven light protected by glass shield

Figure 28: Parts of storage drawer

wire

holder

glass

shield

glide stop

glide rail

drawer support

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43

Comments to this Manuals

No comments

Frigidaire FFGF3056TW Owner's Manual Page 36

Comments to this Manuals

Related products and manuals for Microwaves Frigidaire FFGF3056TW