Frigidaire FGDS3065KW User Manual download pdf (Page 10)

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS

(Models with an Electric Oven and a Gas Cooktop)

Figure 12

Leveling the Range -

Level the range and set cooktop height before

installation in the cut-out opening.

1. Install an oven rack in the center of the oven.

2. Place a level on the rack (Figure 12). Take 2 readings

with the level placed diagonally in one direction

and then the other. Level the range, if necessary, by

adjusting the 4 leg levelers with a wrench.

3. Taking care to not damage the countertop, slide

range into cut-out opening and double check for

levelness.

9.10

Make sure that the underside of the cooktop

clears the countertop. If necessary, raise the unit

by lowering the front leveling legs and the back

leveling wheels.

9.11

Level the range (see section 10). The ﬂoor

where the range is to be installed must be level.

Follow the instructions under "Leveling the

Range".

9.12

Slide the range into the cutout opening.

IMPORTANT

If Accessories Needed :

Range Installation

Important Note: Door removal is not a requirement for

installation of the range, but is an added convenience.

Refer to the Use and Care Guide for oven door removal

instructions.

Standard Installation

9.1

The range cooktop overlaps the countertop at the

sides and the range rests on the ﬂoor. The cooktop

is 31½" (80 cm) wide.

9.2

Install base cabinets 30" (76.2 cm) apart. Make

sure they are plumb and level before attaching

cooktop. Shave raised countertop edge to clear

31½" (80 cm) wide range top rim.

9.3

Install cabinet doors 31" (78.7 cm) min. apart so as

not to interfere with range door opening.

9.4

Cutout countertop exactly as shown on page 1.

9.5

Make sure the four leveling legs are setup higher

than the height of the cabinet (shown on page 3).

9.6

Install the anti-tip bracket at

this point before placing the range at its

ﬁnal position. Follow the installation instructions

on page 13 or on the anti-tip bracket template

supplied with the range.

9.7

To provide an optimum installation, the top surface

of the countertop must be level and ﬂat (lie on the

same plane) around the 3 sides that are adjacent

to range cooktop. Proper adjustments to make

the top ﬂat should be made or gaps between the

countertop and the range cooktop may occur.

9.8

To reduce the risk of damaging your

appliance, do not handle or manipulate it by the

cooktop. Manipulate with care.

9.9

Position range in front of the cabinet opening.

Installation With Backguard

The cutout depth of (21 3/4" (55.2 cm)Min., 22 1/8"

(56.2cm) Max.) needs to be increased to 24" (61 cm)

when installing a backguard.

Installation With End Panel

A End Panel kit can be ordered through a Service

Center.

Installation With Side Panels

A Side Panels kit can be ordered through a Service

Center. Note: Install cabinet doors 31" (78.7 cm) min.

apart so as not to interfere with range door opening.

Moving the Appliance for

Servicing and Cleaning

Turn off the range line fuse or circuit breakers at the

main power source, and turn off the manual gas shut-off

valve. Make sure the range is cold. Remove the service

drawer (warmer drawer on some models) and open the

oven door. Lift the range at the front and slide it out

of the cut-out opening without creating undue strain

on the ﬂexible gas conduit. Make sure not to pinch

the ﬂexible gas conduit at the back of the range when

replacing the unit into the cut-out opening. Replace

the drawer, close the door and switch on the electrical

power and gas to the range.

1 ... 9 10 11 ... 40

Comments to this Manuals

No comments

Frigidaire FGDS3065KW User Manual Page 10

Comments to this Manuals

Related products and manuals for Kitchen Frigidaire FGDS3065KW