Frigidaire FGDS3065KW User Manual download pdf (Page 9)

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS

(Models with an Electric Oven and a Gas Cooktop)

Assemble the ﬂexible connector from the gas supply

pipe to the pressure regulator in the following order:

1. manual shutoff valve (not supplied)

2. 1/2" nipple (not supplied)

3. 1/2" ﬂare union adapter (not supplied)

4. ﬂexible connector (not supplied)

5. 1/2" ﬂare union adapter (not supplied)

6. 1/2" nipple (not supplied)

7. pressure regulator (supplied)

The gas supply line to the shutoff valve should be

1/2"(1,27 cm) or 3/4"(1.9 cm) solid pipe.

The user must know the location of the main shutoff

valve and have easy access to it.

When using ﬂexible gas conduit on the range, allow

sufﬁcient slack to pull the range outside the cutout for

cleaning or servicing.

NOTE: Do not allow the ﬂexible conduit to get pinched

between the wall and the range. To visually check,

remove the range drawer.

Use pipe-joint compound made for use with Natural and

LP/Propane gas

to seal all gas

connections.

If ﬂexible

connectors

are used,

be certain

connectors are

not kinked.

All connections must be wrench-tightened

Figure 10

Flare

Union

Flare

Union

GAS FLOW

Manual

Shutoff

Valve

Pressure

Regulator

Off

Flexible

Connector

Access

Cap

Nipple Nipple

Shutoff Valve -

Open position

to appliance

to gas supply line

Figure 11

The supply line must be equipped with an approved

manual shutoff valve. This valve should be located in

the same room as the range and should be in a location

that allows ease of opening and closing. Do not block

access to the shutoff valve. The valve is for turning on or

shutting off gas to the appliance.

Once regulator is in place, open the shutoff valve in the

gas supply line. Wait a few minutes for gas to move

through the gas line.

Leak testing of the appliance shall be conducted

accordingtothemanufacturer'sinstructions.

Check for leaks. After connecting the range to the gas

supply, check the system for leaks with a manometer. If

a manometer is not available, turn on the gas supply and

use a liquid leak detector at all joints and connections to

check for leaks.

Do not use a ﬂame to check for leaks

from gas connections. Checking for leaks with a ﬂame

may result in a ﬁre or explosion.

All openings in the wall or ﬂoor where the range is to be

installed must be sealed.

Tighten all connections if necessary to prevent gas

leakage in the cooktop or supply line.

Disconnect this range and its individual shutoff

valve from the gas supply piping system during any

pressure testing of the system at test pressures greater

than 1/2 psig (3.5 kPa or 14"(35,56 cm) water column).

Isolate the range from the gas supply piping system

by closing its individual manual shutoff valve during

any pressure testing of the gas supply piping system at

test pressures equal to or less than 1/2 psig (3.5 kPa or

14"(35,56 cm) water column).

LP/Propane Gas Conversion

This appliance can be used with Natural gas or LP/

Propane gas. It is shipped from the factory for use with

natural gas.

If you wish to convert your range for use with LP/

Propane gas, use the supplied ﬁxed oriﬁces located in a

bag containing the literature marked "FOR LP/PROPANE

GAS CONVERSION." Follow the instructions packaged

with the oriﬁces.

The conversion must be performed by a qualiﬁed service

technician in accordance with the manufacturer's

instructions and all local codes and requirements. Failure

to follow these instructions could result in serious injury

or property damage. The qualiﬁed agency performing

this work assumes responsibility for the conversion.

Failure to make the appropriate

conversion can result in personal injury and property

damage.

PRESSURE REGULATOR LOCATION

Figure 9

1 2 3 4 5 6 7 8 9 10 ... 40

Comments to this Manuals

No comments

Frigidaire FGDS3065KW User Manual Page 9

Comments to this Manuals

Related products and manuals for Kitchen Frigidaire FGDS3065KW