Frigidaire FGDS3065KW User Manual download pdf (Page 5)

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS

(Models with an Electric Oven and a Gas Cooktop)

Canada Style

Figure 1

Power Supply Cord Kit (U.S.A.)

The user is responsible for connecting the power supply

cord to the connection block located behind the back

panel access cover.

This appliance may be connected by means of

permanent "hard wiring"; ﬂexible armored or

nonmetallic shielded copper cable (when local code

allow it) or by means of a power supply cord kit.

NOTE: Electric Slide-in Range is shipped from factory

with 1 1/8" (2.9 cm) dia. hole as shown on ﬁgure 4. If a

larger hole is required, punch out the knockout.

Risk of ﬁre or electrical shock exists

if an incorrect size range cord kit is used, the

Installation Instructions are not followed, or the

strain relief bracket is discarded.

For mobile homes, new installations or recreational

vehicles, use only a power supply kit designed for a

range at 125V/250V 30A recommended. Cord must have

either 3 (when local code permits grounding through

neutral) or 4 conductors. Terminal on end of wires must

be either closed loop or open spade lug with upturned

ends. Cord must have strain-relief clamp.

Do not loosen the nuts which secure

the factory-installed range wiring to terminal block

while connecting range. Electrical failure or loss of

electrical connection may occur.

Access to Terminal Block &

Grounding Strap (U.S.A.)

Electrical Shock Hazard

•Electricalgroundisrequiredonthisappliance.

•Donotconnecttotheelectricalsupplyuntil

appliance is permanently grounded.

•Disconnectpowertothecircuitbreakerorfuse

box before making the electrical connection.

•Thisappliancemustbeconnectedtoa

grounded, metallic, permanent wiring system,

or a grounding connector should be connected

to the grounding terminal or wire lead on the

appliance.

Failure to do any of the above could result in a

ﬁre, personal injury or electrical shock.

Factory Connected Power Supply

Cord (Canada only)

This range is equipped with a factory-connected power

cord (see Figure 1). Cord must be connected to a

BEND REAR WIRE COVER HERE

FOR ACCESS TO TERMINAL BLOCK

Figure 2

This appliance is manufactured

with the frame grounded by connection of a

grounding strap between the neutral power

supply terminal and the frame. If used in USA,

in a new branch circuit installation (1996 NEC),

mobile home or recreational vehicule, where

local code do not permit grounding through

neutral(white)wireorinCanada;removethe

grounding strap from the frame and cut the

other end, near the neutral terminal. Connect

the appliance in usual manner.

•Intheeventofanelectricalpoweroutage,thesurface

burners can be lit manually. To light a surface burner,

hold a lit match to the burner head and slowly turn

the Surface Control knob to LITE. Use caution when

lighting surface burners manually.

•Reset all controls to the "off" position after using

a programmable timing operation.

FOR MODELS WITH SELF-CLEAN FEATURE:

•Remove broiler pan, food and other utensils

before self-cleaning the oven. Wipe up excess

spillage. Follow the precleaning instructions in the Use

and Care Guide.

grounded 120/240 volt

or 120/208 volt range

outlet. If no outlet is

available, have one

installed by a qualiﬁed

electrician.

1 2 3 4 5 6 ... 40

Comments to this Manuals

No comments

Frigidaire FGDS3065KW User Manual Page 5

Comments to this Manuals

Related products and manuals for Kitchen Frigidaire FGDS3065KW