Frigidaire FFEH3054US Installation Manual download pdf (Page 3)

30” ELECTRIC FRONT CONTROL FREESTANDING INSTALLATION INSTRUCTIONS

2. Tools You Will Need

3. Anti-Tip Bracket Installation

Instructions

Important Safety Warning

To reduce the risk of tipping of the range, the range should

be secured to the oor by properly installed anti-tip bracket

and screws packed with the range. Failure to install the

anti-tip bracket will allow the range to tip over if excessive

weight is placed on an open door or if a child climbs upon

it. Serious injury might result from spilled hot liquids or from

the range itself.

If range is ever moved to a different location, the anti-tip

brackets must also be moved and installed with the range.

Instructions are provided for installation in wood or cement

fastened to either the oor or wall. When installed to the

wall, make sure that screws completely penetrate dry wall

and are secured in wood or metal. When fastening to the

oor or wall, be sure that screws do not penetrate electrical

wiring or plumbing.

A. Locate the Bracket Using the Template - (Bracket may be

located on either the left or right side of the range. Use

the information below to locate the bracket if template is

not available). Mark the oor or wall where left or right

side of the range will be located. If rear of range is against

the wall or no further than 1-1/4" (32 mm) from wall when

installed, you may use the wall or oor mount method. If

molding is installed and does not allow the bracket to t

ush against the wall, remove molding or mount bracket

to the oor. For wall mount, locate the bracket by placing

the back edge of the template against the rear wall and

the side edge of template on the mark made referencing

the side of the range. Place bracket on top of template

and mark location of the screw holes in wall. If rear of

range is further than 1-1/4" (32 mm) from the wall when

For leveling legs and Anti-Tip Bracket:

• Adjustable wrench or channel lock

pliers

• 5/16" Nutdriver or Flat Head

Screwdriver

• Electric Drill & 1/8" Diameter

Drill Bit (Masonry Drill Bit if

installing in concrete)

• Level & Measuring Tape

For electrical supply connection:

• 1/4" & 3/8" Socket driver or Nutdriver

Additional Materials You Will Need:

• Power Supply Cord or

• Copper Electrical Wiring & Metal

Conduit (for hard wiring)

installed, attach bracket to the oor. For oor mount,

locate the bracket by placing back edge of the template

where the rear of the range will be located. Mark the

location of the screw holes, shown in template.

(32 mm)

B. Drill Pilot Holes and Fasten Bracket - Drill a 1/8” (3 mm)

pilot hole where screws are to be located. If bracket is to

be mounted to the wall, drill pilot hole at an approximate

20° downward angle. If bracket is to be mounted to

masonry or ceramic oors, drill a 5/32” (4 mm) pilot hole

1-3/4” (44 mm) deep. The screws provided may be used

in wood or concrete material. Use a 5/16” (8 mm) nut-

driver or at head screwdriver to secure the bracket in

place.

Fig.4

Fig.5

Fig.6

1 2 3 4 5 6 7 8 ... 15 16

Comments to this Manuals

No comments

Frigidaire FFEH3054US Installation Manual Page 3

Comments to this Manuals

Related products and manuals for Baby furniture Frigidaire FFEH3054US